![]() ![]() ![]() The syntax for configuring a trap is as follows:.You can use Event to Trap Translator to easily create a configuration file and then use the configuration file with evntcmd at the command prompt to quickly configure traps on multiple computers. After you have defined the traps you want, click Export to create a file suitable for use with evntcmd. If you have the SNMP service installed, you can start Event to Trap Translator by typing evntwin at a command prompt. if you want to configure traps but not trap destinations, you can create a valid configuration file by using Event to Trap Translator, which is a graphical utility.Specifies, by name, the configuration file that contains information about the translation of events to traps and trap destinations you want to configure. Specifies that the SNMP service should not be restarted if this computer receives trap configuration changes. If you specify 10, all types of messages appear, including tracing messages and warnings about whether trap configuration was successful. This parameter must be an integer between 0 and 10. Specifies which types of status messages appear as traps and trap destinations are configured. If you do not specify a computer, the configuration occurs on the local computer. ![]() Specifies, by name, the computer on which you want to configure the translation of events to traps, trap destinations, or both. Configures the translation of events to traps, trap destinations, or both based on information in a configuration file. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |